Part Number Hot Search : 
SZ30D0 2SA1572 CLP0612 16C55 DT74FCT3 AT89C5 IRFV064 T8302
Product Description
Full Text Search
 

To Download AGOV5S3 Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com
PRODUCT
D ATA
SHEET
CRYSTAL CONTROLLED OSCILLATORS 14 PIN DIP 5.0V HCMOS STRATUM 3 OCXO
ABSOLUTE MAXIMUM RATINGS
PARAMETER Storage Temperature Supply Voltage Control Voltage UNITS (Vcc) (Vc) MINIMUM -40 -0.5 -0.5 NOMINAL MAXIMUM 85 7.0 7.0 UNITS C Vdc Vdc TABLE 2.0 (Fo) MINIMUM 1.544 -1.5 -0.25 -30 -2.5 -4.6 0 (Vcc) (Icc) 4.75 NOMINAL 5.0 -90 -135 MAXIMUM 20.0 1.5 0.25 30 2.5 4.6 70 5.25 300 1 3 3 10 5 1 2 UNITS MHz ppm ppm ppb ppm ppm C Vdc mA ps rms ps rms ps rms dBc/Hz dBc/Hz mS Minutes nS nS 1 2 3 4 NOTE TABLE 1.0 NOTE
CW 0107 AGOV5S3 12.800M
AGOV5S3
DESCRIPTION
OPERATING SPECIFICATIONS
PARAMETER Center Frequency, Vc=2.18 Vdc Frequency Calibration Frequency Stability Aging (Daily) Aging (20 Years) Total Frequency Tolerance Operating Temperature Range Supply Voltage Supply Current Phase Jitter (BW=12KHz to 20MHz ) Phase Jitter (BW=10Hz to 20MHz) Period Jitter SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Start Up Time: Oscillator Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec.
The Connor-Winfield AGOV5S3 is a hermetically sealed 14 Pin DIP 5.0V Oven Controlled Crystal Oscillator (OCXO) with an HCMOS output. The AGOV5S3 is designed for Stratum 3 applications requiring low jitter and tight frequency stability.
5
FEATURES
TABLE 3.0
INTPUT CHARACTERISTICS
PARAMETER Control Voltage Range Frequency at Vc=0.5 Vdc Frequency at Vc=4.1 Vdc Slope of Frequency Adjust Input Impedance (Vc) MINIMUM 0.5 -30 18 5 100k NOMINAL 2.18 MAXIMUM 4.1 -18 30 UNITS Vdc ppm ppm ppm/V Ohm
NOTE 6 6
FREQUENCY ADJUST 5.0V OPERATION LOW JITTER <1pS RMS TEMPERATURE STABILITY 0.25ppm
HCMOS OUTPUT CHARACTERISTICS
PARAMETER LOAD Voltage (High) (Low) Current (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% MINIMUM 4.5 -4 45 NOMINAL 50 MAXIMUM 15 0.4 4 55 6 UNITS pf Vdc Vdc mA mA % nS
TABLE 4.0 NOTE
TEMPERATURE RANGE: 0 to 70C FREQUENCY TOLERANCE OF 4.6ppm OVER TWENTY YEARS LOW PROFILE 14 PIN DIL PACKAGE
(Voh) (Vol) (Ioh) (Ioh)
PACKAGE CHARACTERISTICS
Package
TABLE 5.0 14 pin DIP, hermetically sealed, grounded case, welded package
ORDERING INFORMATION
Notes: 1) 2) 3) 4)
Initial calibration @ 25C, Vc=2.18 Vdc. Frequency vs. temperature stability At the time of shipment after48 hours of operation. Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration, 20 years aging, Vc=2.18 Vdc. 5) Measured @ 25C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of continuous operation at a stable 25C 6) Referenced to Fo @ 25C, Positive Transfer Characteristic
AGOV5S3
OCXO SERIES
- 12.800MHz
CENTER FREQUENCY
Specifications subject to change without notice. DATA SHEET #: Cx015 PAGE 1 OF 2 REV: 01 DATE: 6/25/03
aCopyright 2001 Connor-Winfield all rights reserved.
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com
PRODUCT
D ATA
SHEET
CRYSTAL CONTROLLED OSCILLATORS
ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55C to 125C, 20 cycles,10 minute dwell, 1m inute transition. Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125C 5C for 20 seconds. SOLDERING Pin Solderability: Per MIL-STD-883, Method 200. 8 hour steam age prior to 254C 5C Solder pot dip, 95% Coverage. Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside board -mount product, 260C 5C for 20 Seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G's peak, 10Hz to 500Hz, 15mi nute cycles 12 times each perpendicular axis. Shock: Per MIL-STD-202, Method 213, Condition D. 500G's, 1ms, half sine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65C, 10 cycles 10C to 65C.
CONTROL VOLTAGE
TEST DIAGRAM
4.1Vdc
5.0Vdc
14
8
1
7
Specifications subject to change without notice. DATA SHEET #: Cx015 PAGE 2 OF 2 REV: 01 DATE: 6/25/03
aCopyright 2001 Connor-Winfield all rights reserved.


▲Up To Search▲   

 
Price & Availability of AGOV5S3

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X